192.168.0.1.1: The IP address 192.168.0.1.1 is the address of some home-use broadband router. It is mainly the default value of a variety of D-Link, TP-Link and Netgear model routers. And you can use the password of 192.168.0.1.1 password using the network router management console at any time. This IP address is a private IPv4 network address. The Home-use router can use it to set up the default gateway. In the router, you can access its management console through a web browser at http://192.168.0.1.1.
If the routers or any computers of any brand on the local network get some problem, use this address. You can also use a similar private IPv4 address to solve it. So, today in this article we provide you the settings requires to change the password of 192.168.0.1 IP Address. Therefore, read this page and the relevant information. Moreover, it is suggested that any IP address on the network, uses the only piece of equipment to use this IP address. It is to avoid conflicts between the addresses.
Reasons For Not Able To Access 192.168.0.1.1
Mostly, in wireless router setup process, we often use the ping command. If your router address is 192.168.0.1.1, then click ‘Run’ (or use the key combination win + R). Now enter CMD and then hit OK. Then enter ping 192.168.0.1.1, if the result returns timeout, it illustrates the network is disconnected. It may be due to losing of packages, and it also means your computer can not connect to the router. However, you can find out the reasons for not getting the access.
Here may be the reasons:
1. The reason may be that the router IP address is not this IP address, or you mistype with 192.168.o.1.1.
2. It may be due to the router has been shut down, and unable to connect.
3. Check for ICMP packet filtering is set up in the router.
Moreover, if you can receive some bytes, it means your network is connected. And you may be able to log into a wireless router, and the step is to enter 192.168.0.1.1 in your browser to try.
How To Change Password of 192.168.0.1.1 IP Address
It is important that you change your router password so that no one can access and reconfigure your router. Make sure to write down new username and password. Below we share with you how to change the password of IP Address of a wireless router.
- First, you need to login to the router control panel by typing in router default IP address.
- If you don’t know router default IP address, then open the command prompt.
- There you type the ipconfig. Then you will get the IP address of the router.
- After entering the IP address, you should see the username and password prompt.
- Now, enter the username and password for the router.
- Then click on the login option.
- The router administration interface will load.
- Then look for the security or administrative tab in the router administrative management interface.
- There you will see a link to “Change password.”
- Click on it and type your password twice there. Make sure your password is strong.
To make your password stronger, you can use online password generators. So, that other user may not be able to hack your password.